Mazda Skyactiv-D 2.2
CAUTION Modern

Skyactiv-D 2.2

Mazda · 2.2L Turbo Diesel I4

2012–present

0 / 100
CAUTION

"Low-compression twin-turbo diesel in the Mazda 3, Mazda 6 and CX-5: refined, economical and strong on the motorway. But 2012-2018 builds carry a long recall record - injector seals letting combustion gas carbonise the oil (clogged oil strainer, worn oil-pump chain, engine damage), intake-shutter carbon causing stalls, early camshaft wear and head-gasket coolant loss. City driving clogs the DPF and dilutes the oil with fuel. Buy only with every recall done and short oil-change intervals documented."

Layout I4
Displacement 2191 cc
Power 150–184 hp
Type Diesel
Known Issues 8
Total Risk Cost €2,950–€30,800

Mileage Risk Timeline

When problems typically appear — enter your mileage to see your risk zone

km

Known Issues 8

◆ CRITICAL

Injector seal leak — carbonised oil, clogged oil strainer, oil starvation (recall)

€450–€9,000 60,000 km–150,000 km
View details ▸
Detection

Oil pressure warning, black sludgy oil, ticking or chuffing from the injectors, sudden stall; on inspection carbon deposits in the oil strainer

Details

Injector mounting nuts were tightened with the wrong torque, so combustion gas leaks past the injector gasket into the oil and carbonises it; the carbon clogs the oil strainer and starves the engine. Recalled in Germany (KBA, 2017, part of 61,061 cars), Austria (builds Feb 2012-Feb 2017) and Hong Kong: injectors re-torqued, oil pressure checked, strainer cleaned and engine flushed if low. A second campaign reprogrammed the PCM after injector-circuit shorts that could stall the engine. Out-of-recall repair range from an aggregator: EUR 450 for seals up to EUR 9,000 when the engine is damaged.

Greece Note

Check the VIN for the injector and PCM recalls before buying. No Greek recall notice was found.

▲ HIGH

Head gasket — combustion gas into coolant, coolant overflow

N/A–N/A N/A–N/A
View details ▸
Detection

Coolant loss, coolant pushed out of the expansion tank under load, engine protection mode cuts power

Details

Under sustained low-rpm, high-load driving (long climbs, high gear) combustion gas leaks past the head gasket into the coolant passages. Mazda Taiwan recall for CX-5 (Mar 2013-Nov 2017) and Mazda6 (Nov 2012-Oct 2017): pressure and CO2 test, engine repaired or replaced if the gasket has failed, PCM update. German and French guides report coolant loss and head-gasket failures. No EUR or km figure in the sources.

Greece Note

Greek mountain roads in a high gear are exactly the load case Mazda describes - change down on long climbs.

▲ HIGH

Intake shutter valve and intake carbon — power loss, stalling (recall)

N/A–N/A N/A–N/A
View details ▸
Detection

Gradual power loss, several warning lights, limp mode, engine stalls and may not restart

Details

Soot builds up on the intake shutter flap so it no longer closes, and on the intake manifold and valves. Recalls: Austria (MY2016-2018, 18,021 cars, software and flap), Australia (2012-2018, about 35,000 cars), Japan (built Feb 2012-Jul 2018: weaker intake-valve springs replaced, throttle software). AUTO BILD reports coked intake manifolds on the second-generation CX-5 too. Fix under recall is free; no out-of-recall EUR or km figure in the sources.

Greece Note

Typical of slow city driving; a regular motorway run helps. Check the VIN for the software recall.

▲ HIGH

Camshaft wear on early engines — metal debris, vacuum pump and turbo damage

€800–€6,500 70,000 km–160,000 km
View details ▸
Detection

Metallic noise, metal particles in the oil, brake-servo vacuum loss, turbo failure

Details

Soft camshafts (material defect) on engines built up to about mid-2013, some sources say to 2014; abrasion debris travels with the oil and destroys the vacuum pump and the turbochargers. Mazda revised the part; later engines are not reported. EUR range from an aggregator covering cam, vacuum pump and debris damage.

Greece Note

Relevant for 2012-2014 imports. Ask for proof of camshaft or vacuum-pump work.

▲ HIGH

Oil pump chain wear and breakage from carbon-laden oil

€900–€10,000 90,000 km–170,000 km
View details ▸
Detection

Oil pressure light (flashing on updated software), engine warning light, car will not accelerate

Details

Carbon particles in degraded oil act as an abrasive and wear the oil-pump drive chain until it breaks and oil stops circulating. Mazda Taiwan recalled 11,459 CX-5 and Mazda6 (built 2012-2017): chain clearance checked and chain replaced if out of spec (about 6.5 hours), PCM updated, oil-change reminder added, and a permanent engine-block warranty granted. French owner reports and an aggregator list the same failure; EUR range from the aggregator. EU recall status not confirmed.

Greece Note

Short Athens trips degrade the oil faster - change it well before the service indicator and keep the receipts.

● MODERATE

DPF clogging and fuel dilution of the engine oil

€300–€1,800 50,000 km–160,000 km
View details ▸
Detection

Oil level rising above the X mark on the dipstick, frequent regenerations (fan running after switch-off), DPF warning

Details

Interrupted regenerations on short trips leave diesel in the sump; the oil level rises and lubrication suffers, which feeds the carbon problems above. Mazda issued new software and a redesigned dipstick in 2012. Requires regular longer runs. EUR range from an aggregator.

Greece Note

Athens stop-and-go is the worst case. Check the dipstick before buying - a level above X means fuel in the oil.

● MODERATE

Twin-turbo failure (often after oil contamination)

€500–€3,500 80,000 km–180,000 km
View details ▸
Detection

Loss of boost, whistling, P0299 underboost code, blue smoke

Details

Turbo failures are the most reported fault in French owner statistics; German guides tie many to debris from worn camshafts and to contaminated oil. EUR range from an aggregator.

Greece Note

No Greek-specific data found.

○ MINOR

Exhaust pressure sensor corrosion — limp mode (recall)

N/A–N/A N/A–N/A
View details ▸
Detection

Engine light, limp mode with EGR, turbo and i-stop disabled

Details

Condensation enters the exhaust (back-)pressure sensor and corrodes its terminals. Covered by recalls in Japan and Taiwan (sensor inspected or replaced, ECU updated). In the auto motor und sport 100,000 km test the sensor was replaced three times.

Greece Note

Cheap if done under recall. No Greek-specific data found.

Models with Skyactiv-D 2.2 11

Related Guides

Other Mazda Engines

Tuning Potential

200hp Stage 1

Frequently Asked Questions

Is the Mazda Skyactiv-D 2.2 reliable?

The Mazda Skyactiv-D 2.2 scores 58/100 with a verdict of CAUTION. It has 8 documented issues with total repair costs between €2,950 and €30,800.

What are the common problems with the Skyactiv-D 2.2?

The most common issues are:

  • Injector seal leak — carbonised oil, clogged oil strainer, oil starvation (recall) — critical, repair cost €450–€9,000, 60,000 km–150,000 km
  • Head gasket — combustion gas into coolant, coolant overflow — high, repair cost N/A–N/A, N/A–N/A
  • Intake shutter valve and intake carbon — power loss, stalling (recall) — high, repair cost N/A–N/A, N/A–N/A
  • Camshaft wear on early engines — metal debris, vacuum pump and turbo damage — high, repair cost €800–€6,500, 70,000 km–160,000 km
  • Oil pump chain wear and breakage from carbon-laden oil — high, repair cost €900–€10,000, 90,000 km–170,000 km
What cars use the Mazda Skyactiv-D 2.2?

The Skyactiv-D 2.2 is found in:

How much does it cost to repair the Skyactiv-D 2.2?

Total potential repair costs for all 8 known issues range from €2,950 to €30,800. The most expensive issue is typically Oil pump chain wear and breakage from carbon-laden oil.

What years was the Skyactiv-D 2.2 produced?

The Mazda Skyactiv-D 2.2 was produced from 2012 to present. It is a 2191cc I4 diesel engine.

Scores are calculated from documented issues, repair costs, and failure patterns across thousands of owner reports and technical sources. Learn about our methodology. Always inspect before you buy.