1GD-FTV
Toyota · 2.8L Turbo Diesel I4
2015–present
"Hilux, Land Cruiser J150/J250 and Fortuner 2.8 diesel. Strong chain-driven workhorse, but 2015-2020 builds had a defective DPF system - white smoke, failed regenerations - that an Australian court ruled made 264,000 vehicles 'not of acceptable quality'. Toyota's hardware and software cure arrived in May 2020. Give it regular highway runs and watch the coolant level (EGR cooler)."
Mileage Risk Timeline
When problems typically appear — enter your mileage to see your risk zone
Known Issues 3
DPF and oxidation catalyst blockage — white smoke, failed regenerations (2015–2020 build)
▸Heavy white foul-smelling smoke on start-up, DPF warning light, regenerations that will not complete (P2458), limp mode, higher fuel use
The after-treatment system of 2015-2020 HiLux, Prado and Fortuner 2.8 (and 2.4 2GD) blocked at the oxidation catalyst and DPF. The Australian Federal Court (2022) found 264,170 vehicles sold Oct 2015-Apr 2020 were not of acceptable quality; after appeals (High Court, Nov 2024) the damages were sent back for reassessment and Toyota agreed an A$750 million settlement. Software updates and a manual regeneration button (2018-19) did not cure it; a new combined DPF and catalyst with new software (May 2020) did and was offered as a retrofit. The fifth (exhaust fuel-addition) injector that heats the DPF was also redesigned in 2020-21. Out of warranty a DPF costs over A$2,000 (approx. EUR 1,200, converted).
No Greek or EU recall was found; EU cars use DPF plus SCR. Ask whether the 2020 after-treatment update was fitted, and avoid an early 2.8 used only in town - Athens traffic is the worst case for regeneration.
EGR cooler internal coolant leak
▸Coolant level dropping in the overflow bottle with no visible leak, white exhaust vapour, overheating if ignored
The EGR cooler cracks from vibration and heat cycling; coolant can enter the engine and cause serious damage. Failures typically 150,000-180,000 km. Replacement quoted at about A$700 by a specialist magazine and A$1,000 at a dealer (approx. EUR 420-600, converted); a cooling-system pressure test finds it.
Check the coolant bottle on every fill-up; Greek summer heat makes a low coolant level more dangerous.
Air box dust bypass — MAF sensor contamination, limp mode
▸Sudden power loss, stability and traction control switching off, limp mode after dusty driving; dust on the clean side of the air box
Fine dust bypasses the air filter and coats the mass air flow sensor. Toyota Australia acknowledged it and offers a dealer cleaning remedy, saying it occurs only in extreme off-road dust; the air box was not redesigned for MY2019.
Relevant to dirt-road and farm use in Greece; check the air box seal and MAF on any HiLux used off-road.
Models with 1GD-FTV 4
Related Guides
Other Toyota Engines
Tuning Potential
200hp+ Stage 1
Frequently Asked Questions
Is the Toyota 1GD-FTV reliable?
The Toyota 1GD-FTV scores 80/100 with a verdict of BUY. It has 3 documented issues with total repair costs between €1,620 and €600.
What are the common problems with the 1GD-FTV?
The most common issues are:
- DPF and oxidation catalyst blockage — white smoke, failed regenerations (2015–2020 build) — high, repair cost €1,200–N/A, N/A–N/A
- EGR cooler internal coolant leak — moderate, repair cost €420–€600, 150,000 km–180,000 km
- Air box dust bypass — MAF sensor contamination, limp mode — minor, repair cost N/A–N/A, N/A–N/A
What cars use the Toyota 1GD-FTV?
The 1GD-FTV is found in:
- Land Cruiser (2024–present)
- Hilux (2015–present)
- Land Cruiser (2015–2021)
- HiLux 2.8 D-4D (2015–2024)
How much does it cost to repair the 1GD-FTV?
Total potential repair costs for all 3 known issues range from €1,620 to €600. The most expensive issue is typically EGR cooler internal coolant leak.
What years was the 1GD-FTV produced?
The Toyota 1GD-FTV was produced from 2015 to present. It is a 2755cc I4 diesel engine.
Scores are calculated from documented issues, repair costs, and failure patterns across thousands of owner reports and technical sources. Learn about our methodology. Always inspect before you buy.