4B11
Mitsubishi · 2.0L NA I4
2007–2018
Capped at 84: scores above 84 need at least 5 independent sources, including an official or specialist one. Rubric result: 94/100.
"Port-injected 2.0 with a timing chain and MIVEC - Lancer X, ASX, Outlander II/III and the 2013-2018 Outlander PHEV. No engine failure pattern is documented; the recalls were for the accessory belt tensioner and pulleys. Expect a chain and crank-seal job somewhere past 150,000 km. No hydraulic lifters, so valve clearances need periodic checks."
Mileage Risk Timeline
When problems typically appear — enter your mileage to see your risk zone
Known Issues 3
Accessory drive belt detachment — tensioner and pulley recalls
▸Squeal or chirp from the belt, battery warning light, sudden loss of power steering assist, engine stall
Two US recalls name 4B1 / 4B11 engines: 14V-562 (2008-2011 Lancer/Outlander - alternator, fan and power-steering pulleys wear and the belt can come off; fix: new belt and pulleys) and 18V-069 (2008-2012 Outlander, 2009-2012 Lancer - the automatic tensioner flange can crack; fix: redesigned tensioner). Free under recall. A Russian guide also reports the accessory-drive rollers wearing at 70,000-80,000 km. European coverage of the campaigns was not verified.
Ask for proof the belt tensioner and pulleys were replaced, or inspect them. No Greek recall notice was found.
Crankshaft front seal oil leak
▸Oil on the crankshaft pulley and lower engine, oil spots under the car, burning-oil smell
The front crankshaft seal often leaks after 100,000-140,000 km; oil reaching the pulley damper can damage it. A US owner complaint describes the seal wearing a groove in the pulley. No EUR figure in any reachable source.
Look under the engine on a test drive. No Greek-specific data found.
Timing chain stretch and MIVEC sprocket wear — high mileage
▸Rattle for a few seconds after a cold start, camshaft timing fault codes
The chain can stretch from about 150,000 km and typically lasts to about 200,000 km. A chain kit is cheap; worn variable-timing sprockets make the job expensive. No EUR figure in any reachable source.
Listen to a cold start on a high-mileage car. No Greek-specific data found.
This report covers the combustion engine only. Battery and electric motor reliability are not included.
Models with 4B11 8
Other Mitsubishi Engines
Tuning Potential
N/A
Frequently Asked Questions
Is the Mitsubishi 4B11 reliable?
The Mitsubishi 4B11 scores 84/100 with a verdict of BUY. It has 3 documented issues with total repair costs between €0 and €0.
What are the common problems with the 4B11?
The most common issues are:
- Accessory drive belt detachment — tensioner and pulley recalls — moderate, repair cost €0–N/A, 70,000 km–80,000 km
- Crankshaft front seal oil leak — minor, repair cost N/A–N/A, 100,000 km–140,000 km
- Timing chain stretch and MIVEC sprocket wear — high mileage — minor, repair cost N/A–N/A, 150,000 km–200,000 km
What cars use the Mitsubishi 4B11?
The 4B11 is found in:
- Outlander (2007–2012)
- ASX (2010–2023)
- Outlander (2012–2021)
- Lancer (2008–2017)
- Outlander (2014–2021)
- Lancer 2.0 MIVEC (2007–2017)
- Outlander 2.0 MIVEC (2012–2021)
- Outlander PHEV (2013–2024)
How much does it cost to repair the 4B11?
Total potential repair costs for all 3 known issues range from €0 to €0.
What years was the 4B11 produced?
The Mitsubishi 4B11 was produced from 2007 to 2018. It is a 1998cc I4 petrol na engine.
Scores are calculated from documented issues, repair costs, and failure patterns across thousands of owner reports and technical sources. Learn about our methodology. Always inspect before you buy.