BUY Recovery

4B10

Mitsubishi · 1.8L MIVEC I4

2007–2017

0 / 100
BUY

"Simple naturally aspirated 1.8 with a timing chain and port injection - Lancer X and ASX. Generally long-lived; the chain and MIVEC sprockets can stretch and rattle from about 150,000 km. No hydraulic lifters: valve clearances are set with shims, which makes LPG conversions costlier to look after."

Layout I4
Displacement 1798 cc
Power 139–143 hp
Type Petrol Na
Known Issues 4
Total Risk Cost €0–€0

Mileage Risk Timeline

When problems typically appear — enter your mileage to see your risk zone

km

Known Issues 4

● MODERATE

Timing chain stretch — cold-start rattle, worn MIVEC sprockets

N/A–N/A 150,000 km–200,000 km
View details ▸
Detection

Rattle for a few seconds after a cold start, check-engine light, power loss or hard starting when the chain has stretched

Details

The chain is generally durable but often stretches and rattles after 150,000-200,000 km; the variable-timing (MIVEC) sprockets can wear too and are the expensive part. Owners report stretched chains diagnosed on power loss. Use quality kits. No EUR figure in any reachable source.

Greece Note

Listen to a cold start before buying a high-mileage Lancer 1.8. No Greek-specific data found.

○ MINOR

Oil consumption at high mileage

N/A–N/A N/A–N/A
View details ▸
Detection

Oil level dropping between services, blue smoke on start-up

Details

Reported as a typical 4B10 complaint at high mileage, attributed to worn piston rings or valve-stem seals. Not universal: some owners report none at 175,000 km. No EUR or km figures in any source.

Greece Note

Check the oil level and service history. No Greek-specific data found.

○ MINOR

Valve clearance set by shims (no hydraulic lifters) — costly adjustment, important on LPG

N/A–N/A N/A–N/A
View details ▸
Detection

Tappet ticking, especially warm; misfires or hard starting if clearances close up (LPG)

Details

The 4B10 has no hydraulic lifters: clearances must be checked periodically and corrected by replacing shims, which costs more than screw adjustment. This matters most on LPG conversions, where valve clearances close faster. The later 4J10 1.8 (SOHC) uses screw adjusters instead. No EUR or interval in any source.

Greece Note

Many Lancer 1.8s run on LPG - ask for proof of valve clearance checks. No Greek-specific data found.

○ MINOR

Oil leaks — crankshaft front seal and valve cover gasket

N/A–N/A 100,000 km–140,000 km
View details ▸
Detection

Oil on the crankshaft pulley or the front of the engine, oily valve cover edge, burning-oil smell

Details

The crankshaft front seal often leaks after 100,000-140,000 km; leaking oil can destroy the rubber of the pulley damper. The valve cover gasket also seeps. Cheap parts; no EUR figure in any source.

Greece Note

Look under the engine and at the pulley before buying. No Greek-specific data found.

Models with 4B10 2

Other Mitsubishi Engines

Tuning Potential

N/A

Frequently Asked Questions

Is the Mitsubishi 4B10 reliable?

The Mitsubishi 4B10 scores 82/100 with a verdict of BUY. It has 4 documented issues with total repair costs between €0 and €0.

What are the common problems with the 4B10?

The most common issues are:

  • Timing chain stretch — cold-start rattle, worn MIVEC sprockets — moderate, repair cost N/A–N/A, 150,000 km–200,000 km
  • Oil consumption at high mileage — minor, repair cost N/A–N/A, N/A–N/A
  • Valve clearance set by shims (no hydraulic lifters) — costly adjustment, important on LPG — minor, repair cost N/A–N/A, N/A–N/A
  • Oil leaks — crankshaft front seal and valve cover gasket — minor, repair cost N/A–N/A, 100,000 km–140,000 km
What cars use the Mitsubishi 4B10?

The 4B10 is found in:

How much does it cost to repair the 4B10?

Total potential repair costs for all 4 known issues range from €0 to €0.

What years was the 4B10 produced?

The Mitsubishi 4B10 was produced from 2007 to 2017. It is a 1798cc I4 petrol na engine.

Scores are calculated from documented issues, repair costs, and failure patterns across thousands of owner reports and technical sources. Learn about our methodology. Always inspect before you buy.