N52
BMW · 2.5-3.0L NA I6
2004–2015
"Port-injected naturally aspirated straight-six, smooth and long-lived - owners regularly see 200,000 miles. Budget for the electric water pump and thermostat, oil filter housing and valve cover leaks, and check that the VANOS-bolt recall was done on 2009-2011 builds."
Mileage Risk Timeline
When problems typically appear — enter your mileage to see your risk zone
Known Issues 7
VANOS housing bolts can loosen or break - power loss or stall (recall)
▸Sudden loss of power, rough running, camshaft timing fault codes, engine stalling
The aluminium bolts that hold the VANOS (variable camshaft timing) unit housing can loosen over time and break, which can cut power or stall the engine. BMW recalled 2010-2011 N52 cars (128i, 328i, Z4 sDrive30i, X3 xDrive28i/30i, X5 xDrive30i) in the US in 2014 (14V-176) and again in 2023 (23V-707, 2010-2012 builds); the four bolts are replaced free. German and US guides date the affected builds September 2009 to November 2011.
Ask a BMW dealer to check by VIN whether the VANOS bolt campaign was done. No Greek-specific data found.
Oil filter housing gasket leak - oil can reach the drive belt
▸Oil under the front of the engine, burnt-oil smell, oil around the intake manifold or on the drive belt
The gaskets under the oil filter housing harden with age on all N52s. Oil can soak the serpentine belt, which can then slip off and damage the front crank seal. A gasket job, but it should not be put off.
Look under the front of the engine and at the belt before buying. No Greek-specific data found.
Valve cover gasket leak / cracked plastic valve cover
▸Oil in the spark-plug wells, misfires, burning-oil smell, oil on the cylinder head
One of the most common N52 repairs. Engines built from September 2006 (N52K) have a plastic valve cover instead of magnesium that can warp and crack with heat; the gasket and spark-plug tube seals harden. Parts specialists put onset at about 60,000-100,000 miles.
Greek summer heat cycles age plastic and rubber faster. No Greek-specific data found.
VANOS solenoid / oil feed failure
▸Rough idle, check engine light, loss of low-end torque, rattle on startup
Electric VANOS solenoids clog with dirty oil or fail, giving rough idle and lost low-end torque; cleaning sometimes helps, otherwise they are replaced. About USD 178 in parts plus about USD 200 labour (approx. EUR 165-350, converted); reported at about 70,000 miles (one guide) to 80,000-130,000 miles (parts specialist).
Oil change history critical. Neglected oil causes solenoid clogging.
Electric water pump / thermostat failure - sudden overheating
▸Overheating warning, often with little notice; coolant leaks or steam; very slow warm-up if the thermostat sticks open
The plastic electric water pump is the best-documented N52 failure and N52K engines (from September 2006) got a revised pump said to fail more often. Owners report failures from about 60,000 to 135,000 miles and overheating within a mile when it goes; workshops replace pump and thermostat together, often preventively around 80,000 miles. About USD 400 for the pump, about USD 800 fitted (approx. EUR 370-740, converted). The plastic expansion tank, hoses and thermostat flange age at the same time.
Greek summer heat makes a sudden pump failure more dangerous - stop at once if the temperature rises. Ask whether the pump has been renewed. No Greek-specific data found.
Hydraulic lifter tick on cold start
▸Ticking first 10-30 sec after cold start, disappears warm
Hydraulic lifters on engines built before late 2008 can be short of oil and tick after a cold start. BMW fitted upgraded lifters from October-December 2008. Annoying but not harmful; the permanent fix (new lifters) is a large job, so most owners live with it and keep the oil fresh.
Less concern in Greek climate — warm starts mean shorter tick duration. Keep oil fresh at 7-8k km.
Valvetronic eccentric-shaft sensor failure
▸Rough idle, check-engine light with Valvetronic codes (2A82/2A87 family), oil inside the sensor connector
The sensor that reads the Valvetronic eccentric shaft fails or is contaminated by oil from a leaking valve cover; owners advise replacing it if oil is found in the connector. Ignoring it can bring limp mode.
No Greek-specific data found.
Models with N52 13
Related Guides
Other BMW Engines
Tuning Potential
N/A — classic engine
Frequently Asked Questions
Is the BMW N52 reliable?
The BMW N52 scores 81/100 with a verdict of BUY. It has 7 documented issues with total repair costs between €535 and €1,090.
What are the common problems with the N52?
The most common issues are:
- VANOS housing bolts can loosen or break - power loss or stall (recall) — high, repair cost N/A–N/A, N/A–N/A
- Oil filter housing gasket leak - oil can reach the drive belt — moderate, repair cost N/A–N/A, N/A–N/A
- Valve cover gasket leak / cracked plastic valve cover — moderate, repair cost N/A–N/A, N/A–N/A
- VANOS solenoid / oil feed failure — moderate, repair cost €165–€350, 113,000 km–209,000 km
- Electric water pump / thermostat failure - sudden overheating — moderate, repair cost €370–€740, 97,000 km–145,000 km
What cars use the BMW N52?
How much does it cost to repair the N52?
Total potential repair costs for all 7 known issues range from €535 to €1,090. The most expensive issue is typically Electric water pump / thermostat failure - sudden overheating.
What years was the N52 produced?
The BMW N52 was produced from 2004 to 2015. It is a 2996cc I6 petrol na engine.
Scores are calculated from documented issues, repair costs, and failure patterns across thousands of owner reports and technical sources. Learn about our methodology. Always inspect before you buy.