5.2 FSI V10
Audi · 5.2 FSI V10 NA (S6 C6 BXA, S8 D3, R8 Type 42)
2006–2015
"Naturally aspirated 5.2 direct-injection V10 of the S6 C6, S8 D3 and first-generation R8 V10. No engine recall and few complaints, but it is an expensive engine to keep: intake valves coke up like all FSI engines and need periodic walnut cleaning, and the timing chains sit at the back, so chain or guide work means taking the engine out. Buy with full service history."
Mileage Risk Timeline
When problems typically appear — enter your mileage to see your risk zone
Known Issues 3
Timing chain and guide wear (rear-mounted, engine-out job)
▸Rattle at cold start, camshaft-crankshaft correlation fault codes
The timing chains are driven from the back of the engine, so chain, guide or tensioner work requires removing the engine (about 20 hours of labour reported by owners). An engine database reports chains often needing replacement around 150,000 km and calls the job very expensive; an owner summary notes there are no widespread reports of chain failures. No EUR figure in any reachable source.
No Greek-specific data found.
Intake-valve carbon build-up (direct injection)
▸Gradual power loss, rough idle, misfires at cold start, intake-manifold flap fault codes
Because fuel is injected straight into the cylinders, oil vapour bakes onto the intake valves. Owners report noticeable power loss (one cleaning recovered about 25 hp at the wheels) and intake-manifold faults linked to carbon. Walnut-blast cleaning is recommended every 60,000-80,000 miles (about 97,000-129,000 km) at USD 400-800 (about EUR 370-740, converted).
Short city trips speed up carbon build-up. No Greek-specific data found.
Ignition coil failure (10 coils)
▸Misfire on one cylinder, flashing engine light, misfire codes
Ignition coils are listed among the weak points of the 5.2 FSI V10; ten coil-on-plug units mean replacements come up over the life of the car. Fit genuine coils. No EUR or km figures in any reachable source.
No Greek-specific data found.
Models with 5.2 FSI V10 2
Related Guides
Other Audi Engines
2.5 TFSI I5 (EA855: CEPA, CZGA/CZGB, DAZA, DNWA)
2.5L Turbo I5
View details → Compare: 5.2 FSI V10 vs 2.5 TFSI I5 (EA855: CEPA, CZGA/CZGB, DAZA, DNWA)4.0 TDI V8 EA898
4.0 TDI V8 EA898 (CZAC/DCZF) SQ7/SQ8
View details → Compare: 5.2 FSI V10 vs 4.0 TDI V8 EA8985.2 FSI V10 Gen 2 (dual injection)
5.2 FSI V10 NA Gen 2 (R8 Type 4S, CSPA/CSPB)
View details → Compare: 5.2 FSI V10 vs 5.2 FSI V10 Gen 2 (dual injection)EA837 3.0 TFSI supercharged
3.0L TFSI Supercharged V6
View details → Compare: 5.2 FSI V10 vs EA837 3.0 TFSI superchargedTuning Potential
Supercharger to 700hp+
Frequently Asked Questions
Is the Audi 5.2 FSI V10 reliable?
The Audi 5.2 FSI V10 scores 83/100 with a verdict of BUY. It has 3 documented issues with total repair costs between €370 and €740.
What are the common problems with the 5.2 FSI V10?
The most common issues are:
- Timing chain and guide wear (rear-mounted, engine-out job) — high, repair cost N/A–N/A, 150,000 km–N/A
- Intake-valve carbon build-up (direct injection) — moderate, repair cost €370–€740, 97,000 km–129,000 km
- Ignition coil failure (10 coils) — minor, repair cost N/A–N/A, N/A–N/A
How much does it cost to repair the 5.2 FSI V10?
Total potential repair costs for all 3 known issues range from €370 to €740. The most expensive issue is typically Intake-valve carbon build-up (direct injection).
What years was the 5.2 FSI V10 produced?
The Audi 5.2 FSI V10 was produced from 2006 to 2015. It is a 5204cc V10 petrol na engine.
Scores are calculated from documented issues, repair costs, and failure patterns across thousands of owner reports and technical sources. Learn about our methodology. Always inspect before you buy.